6
TEXI Tronic 5 operation manual
5. Fastening the needle
Before fastening the needle, turn power off.
1. Select needle size and tip appropriate to the stitch
and material type.
2. Turn the pulley until the needle bar is found in its
highest point.
3. Loosen screw [2] and hold the needle with part A
directed to direction B.
4. Insert needle in the direction indicated by the ar-
row, until stops.
5. Tighten screw securely [2].
6. Check if the needle’s long groove C is directed in
direction D.
6. Insertion of bobbin into bobbin case
1. Hold the bobbin so that the thread is directed to the
left, and insert it into the bobbin holder.
2. Lead the thread through the gap and pull it in direc-
tion C. This way, the thread will pass under the flat
bobbin case spring.
3. Check that the bobbin rotates in the direction of the
arrow after it is pulled.
7. Threading the machine
To Next Page
Loading...
