4
TEXI Tronic 5 operation manual
2. Installation
Installation of the oil reservoir:
The oil reservoir should rest upon four corners of the cut-out in the machine table-top (Fig. 1).
- Fasten the two-armed washer [1] on side A of the oil reservoir [3], in the direction of the operator, Fig. 2.)
- Fasten the two washers [2] on side B of the oil reservoir [3], (from the side of the hinges), then fasten the oil res-
ervoir [3] (Fig. 1, Fig. 2).
Machine head installation
- Insert hinge [1] into the opening in the machine head, place machine head on table-top with the hinge in the re-
cess and fasten it on the washers in the four corners of the reservoir (Fig. 3, Fig. 4).
Attention: In the packaging, the four rubber washers placed in the corners of the oil reservoir, are for transportation
purpose only.
3. Lubrication
1. Fill the oil reservoir [1] with high-speed machine oil,
up to the level of upper marker A.
2. When the oil level falls to the level of lower marker
B, refill the reservoir.
3. During machine operation, oil spatter will be visible
in the eye-hole. Remember that the amount of oil
spatter is not related to the amount of oil in the oil
reservoir.
*Attention: during first machine start-up, or after a long
idle time, it should be started at a speed of 2000/min
to 2500/min for about 10 minutes, in order to grind in
co-acting parts.
To Next Page
Loading...
