15
TEXI Tronic 5 operation manual
26. Changing pedal pressing force
1. Setting pressure necessary for pressing the front
part of the pedal:
1) The pressure can be changed by setting the
position of the pressure regulation spring [1].
2) Pressure is decreased when the spring is at-
tached on the left side.
3) Pressure is increased when the spring is at-
tached on the right side.
2. Setting pressure necessary for pressing the back
part of the pedal:
1) This pressure can be set by using regulation
screw [2].
2) Pressure increases when screw is tightened.
3) Pressure decreases when screw is loosened.
3. Setting pedal stroke:
Pedal stroke decreases when the connecting rod [3]
is placed in the left opening.
27. Pedal regulation
1. Tension rod regulation:
Shift pedal to the right or left according to the ar-
rows so that the motor control lever and tension rod
are aligned.
2. Pedal angle regulation:
1) Pedal angle can be set at will by changing the
tension rod length.
2) Loosen regulation screw and set tension rod
length.
To Next Page
Loading...
