Texi Tronic 5 - Correct Oil Dosage to the Hook

5
TEXI Tronic 5 operation manual
4. Correct oil dosage to the hook
1. Before starting regulation:
1) First, for testing, the new machine should operate for about 3 minutes without material.
2) Checking oil using the paper oil level indicator should be carried out during the machine’s operation.
Make sure that the oil level in the oil pan is between the upper and lower marker.
3) The time for checking oil level should be 5 seconds.
2. Oil level
An insufficient amount of oil can cause hook overheat or seizing; too much oil can cause staining of the sewed
material.
3. Regulation of oil dosage to the hook:
Attention: Check oil amount three times and set oil amount so that the mark on the paper oil level indicator is the
same every time.
1) After turning the screw located on the front sleeve of the lower shaft in direction A, the oil dosage will increase;
in direction B - it will decrease.
2) After carrying out regulation, activate the machine for 30 seconds without material to check if the amount of oil
is correct.