(3) Press the
ENTER
/
CHECK
key to validate setting.
The function LED in the center of the panel goes on.
● OFF TIMER (Lit)
○ DELAY
○ Hi-Ω
(4) Then, set intended time with the encoder.
Press the
ENTER
/
CHECK
key to validate setting. Setting is complete now.
The time may be set in units of ten minutes to a maximum of 99 hours
and 50 minutes. The function LED begins to blink when the
remaining time becomes less than five minutes.
The remaining time of the off-timer may be checked by pressing the
ESP/DISP key while the off-timer is running. (On the 400L2,
display changes in the order of CHA, CHB, and remaining time of
the off-timer.)
Timer set to ten minutes
(5) Press the
ESC
/
DISP
key to quit the setting mode and return to the
normal state.
To Next Page
