Operation - 5 - 6 CD397-Oper
August 2018 (Rev B)
Mobile Belt Loader Model 660-28 Operation
Operation Manual Section 5
5.4.6Pre-OperationChecks
1. Perform Pre-operational checks.
2. Remove the warning tag from the cab, and start the unit.
3. Start the unit.
4. Operate the system at no load conditions to ensure that all the systems are operating correctly
before returning the unit to service.
5.5ColdWeatherStorage
The Belt Loader can be stored at temperatures down to -40°F (-40°C) in the standard configuration. It can
be stored down to -65°F ( -54°C) if the following steps are taken:
1. Perform all steps for the long term storage as in previous section.
2. Enclosure the following components are removed from the vehicle and stored in a safe, warm
location:
a. Batteries
b. Serpentine belt
c. Drain the radiator and engine block of coolant
d. Drain the windshield washer fluid (If equipped)
5.6ReturningtheVehicletoOperationAfterColdStorage
The following components, which were removed from the tractor and stored in a safe, warm location need
to be re-installed on the tractor:
a. Batteries
b. Serpentine belt
5.6.1RefillFluids
1. Radiator and engine block coolant
2. Windshield washer tank
3. Perform all steps for returning the tractor to operation after long term storage
NOTE:
The unit may run rough and smoke for a few minutes until it has cleared all the preservatives
from the system.
Property of American Airlines
To Next Page