TRANSAXLE DISASSEMBLY
Page A-4
Dana Electric Transaxle Shop Rebuild and Parts Manual
Input Gear Assembly Removal
1. At axle housing, using a seal puller, remove oil
seal from Input Gear Assembly. Discard oil seal.
(Ref Fig. A-11 on page A-4)
Fig. A-11 Removing Oil Seal from Input Gear
Assembly
2. At axle housing, remove retaining ring from input
gear assembly.
(Ref Fig. A-12 on page A-4)
Fig. A-12 Removing Retaining Ring from Input Gear
Assembly
3. At axle housing, remove input gear assembly. The
input shaft bearing and housing should be a slip-
fit. Use channel-lock or standard pliers for gripping
and removing. Discard O-ring found in the differ
-
ential housing groove. (Ref Fig. A-14 on page A-
4). Two bearings remain assembled to input gear
assembly. (Ref Fig. A-13 on page A-4) (Ref Fig. A-
14 on page A-4)
Fig. A-13 Oil Seal, Retaining Ring, and Input Gear
(With Two Bearings Attached) Removed
4. Remove O-ring from axle housing. Discard O-ring.
Fig. A-14 Axle Housing with Input Gear Assembly
and Hardware Removed
To Next Page
Loading...
