TRANSAXLE REASSEMBLY
Page C-2
Dana Electric Transaxle Shop Rebuild and Parts Manual
Intermediate Gear Assembly Installation
1. Lubricate two O-rings with 30W motor oil and
install them into axle housing.
(Ref Fig. A-1 on
page C-2)
Fig. A-1 Intermediate Gear Assembly O-Rings
Installed
2. If damaged or removed, install two new O-rings on
intermediate gear assembly shaft.
3. Tilt intermediate gear assembly (1) upward on
wide opening of axle housing (2), lower over slot,
and slip into gear housing.
Fig. A-2 Intermediate Gear Assembly Components
4. Push intermediate gear assembly (1) toward nar-
row side of gear housing and install bearing (3) on
intermediate gear assembly shaft (4).
5. Push intermediate gear assembly (1) toward wide
opening of axle housing (2) and install bearing (5)
on intermediate gear assembly shaft (4).
(Ref Fig.
A-3 on page C-2)
Fig. A-3 Intermediate Gear Assembly Installed
6. Using snap-ring pliers, install two retaining rings
into axle housing.
(Ref Fig. A-4 on page C-2)
Fig. A-4 Retaining Rings Installed
To Next Page
Loading...
