Textron EZGO 610987 - Input Gear Assembly Installation

TRANSAXLE REASSEMBLY
Page C-4
Dana Electric Transaxle Shop Rebuild and Parts Manual
Input Gear Assembly Installation
1. Lubricate O-ring with 30W motor oil and install into
axle housing groove.
(Ref Fig. A-9 on page C-4)
Fig. A-9 O-Ring Installed in Input Gear Assembly
2. Install input gear assembly (with bearings) into
axle housing by tilting assembly slightly upward at
an angle while pushing inward to clear the inter
-
mediate gear.
Fig. A-10 Oil Seal, Retaining Ring, and Input Gear
(With Two Bearings Attached)
3. Install retaining ring into the axle housing groove.
(Ref Fig. A-11 on page C-4)
Fig. A-11 Installing Retaining Ring into Input Gear
Assembly and Axle Housing
4. Install oil seal over input gear assembly and into
axle housing. Seal must be installed evenly by
using a seal driver or similar tool.
(Ref Fig. A-12 on
page C-4)
Fig. A-12 Installing Oil Seal into Input Gear
Assembly