TRANSAXLE REASSEMBLY
Page C-3
Dana Electric Transaxle Shop Rebuild and Parts Manual
7. Install two new end cap plugs into axle housing.
(Ref Fig. A-5 on page C-3)
Fig. A-5 End Cap Installed
Differential-Carrier Assembly Installation
1. Install drive gear (2) on differential-carrier (3)
using four hex head bolts and four locknuts (1).
Tighten locknuts to 55 to 63 lb-ft (75 to 85 N•m).
Fig. A-6 Saddle Bolts, Saddles, and
Differential-Carrier Assembly Removed
2. Position differential-carrier into axle housing. (Ref
Fig. A-7 on page C-3)
Fig. A-7 Installing Differential-Carrier into
Axle Housin
g
For accurate torque readings, make sure threads are
clean and lightly lubricated.
Make sure the saddles are installed in their original positions
and orientation. Align the saddles with the alignment marks
prior to installation.
3. Install saddles into axle housing using four saddle
bolts. Tighten bolts to 35 to 45 lb-ft (46 to 61 N•m).
(Ref Fig. A-8 on page C-3)
Fig. A-8 Installing Saddle Bolts and Saddles
To Next Page
Loading...
