Textron EZGO 610987 - Axle Shaft Assembly Removal

TRANSAXLE DISASSEMBLY
Page A-3
Dana Electric Transaxle Shop Rebuild and Parts Manual
Axle Shaft Assembly Removal
1. Remove outside axle nut, spacer, and hub from
driver-side axle tube, using a 15/16" socket.
Repeat on passenger-side axle tube.
(Ref Fig. A-7
on page A-3) (Ref Fig. A-8 on page A-3)
Fig. A-7 Assembled End of Axle Tube
Fig. A-8 Hardware and Hub Removed from End of
Axle Tube
2. Remove outer snap ring and axle shaft from
driver-side axle tube. The bearing, inner snap ring,
and oil seal remain assembled to axle shaft.
Repeat on passenger-side axle tube.
(Ref Fig. A-9
on page A-3) (Ref Fig. A-10 on page A-3)
Fig. A-9 Axle Shaft, Outer Snap Ring, and Bearing
Shown Assembled in Axle Tube
Fig. A-10 Removing Axle Shaft From Axle Tube
3. Remove bearing, inner snap ring, and oil seal from
driver-side axle shaft. Repeat on passenger-side
axle shaft.