Channel The channel that the N1200 uses to communicate with client
devices.
Auth Mode Authentication mode used by the N1200.
Shared: Shared key authentication
Open: Open key authentication
WEP Enable Specifies whether to use encryption for transmission or not.
Key Length Key length specifies the level of encryption used by the N1200.
64 bit: 10 characters from 0 ~ 9 and A ~ F.
128 bit: 26 characters from 0 ~ 9 and A ~ F.
WEP KEY 1
WEP KEY 2
WEP KEY 3
WEP KEY 4
Input up to 4 WEP keys, and select the one you wish to use.
When connecting, be sure to enter the same key and select the
same index number on each client machine.
A DHCP server can be configured to assign IP addresses to devices connected to
LAN ports.
WLAN DHCP Configuration
Item Description
DHCP Server Select to enable or disable DHCP server.
Start IP Specifies the starting IP address of the DHCP range.
End IP Specifies the ending IP address of the DHCP range.
DNS Server Specifies the DNS server IP address.
Web Services Configuration
From the Network menu,
choose the Service item, and
the Web Service screen
appears. This screen displays
the service support
parameters of the system.
You can change any of these
items and press Apply to
confirm your settings. A
description of each item
follows:
NOTE
Users should obey the international RF regulatory rules as they set up the wireless
RF channel on the N1200. The RF operating channels for different regions have
been specified as following. Thecus has no responsibility for users attempting to
violate the international RF regulation.
11 N. America
14 Japan
13 Europe (ETSI)
2 Spain
4
To Next Page
Loading...
Need help?
General