4. Click “Finish” and the data guard task will appear in the list as shown below.
From the task list, you can now see the newly added “customback01”. This backup
is setup as “schedule”.
iSCSI Backup
If the source unit contains iSCSI volume, it can be backed up to the target unit as
a single file. The procedure is the same as for the previous “Full backup” and
“Custom backup”, select “iSCSI backup” from data guard wizard.
1. Inputs the share folder name of the target sever where the source is going to
backup. The sub-folder can be left as blank.
To Next Page
Loading...
