Next, allocate capacity for the iSCSI thin-provision volume by dragging the
Allocation bar to the desired size.
After the size has been determined, click OK to confirm. Now you will see the iSCSI
thin-provisioning volume is available from the list. Please refer to the screenshot
below.
If creating an iSCSI target volume under “Instant Allocation”, physical memory is
assign to the target, being limited by the available memory. For the iSCSI target
volume created under “thin-provisioning”, virtual memory is assigned to the
volume, which can go up to 16384GB (16TB).
LUN ACL
After iSCSI target has been created, you are one step away from using the iSCSI
volume. Under “LUN ACL”, you need to add “Initiator iqn” and setup ACL access
privileges to determine the accessibility. Please refer the screen shot below for
where “Initiator iqn” can be found.
To Next Page
Loading...
