Uninterrupted Power Source
From the External Devices menu, choose the Uninterrupted Power Source
item and the UPS Setting screen appears. Make any changes you wish, and press
Apply to confirm changes.
See the following table for a detailed description of each item.
Enable or disable UPS monitoring.
Enable or disable Remote UPS monitoring.
Input the IP address of the NAS that the UPS
device is connected to via USB or RS232.Input the
IP address of your network UPS.
Choose the UPS manufacturer from the
dropdowns.
Choose the UPS model number from the
dropdowns.
Current status of the UPS battery
Current status of the power being supplied to the
UPS
Seconds between power failure and
first notification
Delay between power failure and first notification
in seconds.
Seconds between subsequent power
failure notifications
Delay between subsequent notifications in
seconds.
Shutdown the system when the
battery charge is less than
Amount of UPS battery remaining before system
should auto-shutdown.
Press Apply to save your changes.
Chapter 5: Tips and Tricks
USB and eSATA Storage Expansion
The Thecus IP storage supports external USB hard disks through its USB ports.
Once a USB hard disk is successfully mounted, the entire volume will be linked
automatically to the default USB HDD folder. The Thecus IP storage supports USB
external storage devices. All file names on the USB disk volume are case sensitive.
To Next Page
Loading...
Need help?
General