Below is a table listing of possible RAID migration schemes:
[RAID 1] HDDx2 to [RAID 5] HDDx3
[RAID 1] HDDx2 to [RAID 5] HDDx4
[RAID 1] HDDx3 to [RAID 5] HDDx4
[RAID 1] HDDx2 to [RAID 6] HDDx4
[RAID 1] HDDx3 to [RAID 6] HDDx4
[RAID 5] HDDx3 to [RAID 5] HDDx4
[RAID 5] HDDx3 to [RAID 6] HDDx4
NAS Stacking
The Thecus IP storage’s capacity can be expanded even further using the stackable
function. With it, users can expand the capacity of their network storage systems
up to 5 other stack target volumes which are located in different systems. These
can be stacked through single network access like SMB or AFP acting as a share
folder type.
From the main menu, the stackable feature is located under “Storage”. Please refer
the figure below for reference.
A. Add a Stack Target Volume
From the figure above, click Add to access the stackable target device
configuration page. Please refer to the figure below:
With the added stack target you can “Enable” or “Disable” the stack target now or
later depending on usage required.
To Next Page
Loading...
Need help?
General