SSH
The device is now SSH protocol supported. It allows user to use SSH and have
console to manipulate as needed. The SSH default login user name is “root” with
full privilege and password is admin’s password. The default admin password is
“admin” so once the admin password has changed then SSH login need to change
the password too.
A description for each item as following:
Enable or disable SSH service.
The port number is default 22.
Enable or disable SFTP protocol under SSH service.
Click “Apply” to confirm the changes.
DDNS
To set up a server on the Internet and enable the users to connect to it easily, a
fixed and easy-to remember host name is often required. However, if the ISP
provides only dynamic IP address, the IP address of the server will change from
time to time and is difficult to recall. You can enable the DDNS service to solve the
problem.
After enabling the DDNS service of the NAS, whenever the NAS restarts or the IP
address is changed, the NAS will notify the DDNS provider immediately to record
the new IP address. When the user tries to connect to the NAS by the host name,
the DDNS will transfer the recorded IP address to the user.
The NAS supports the DDNS providers:
DyDNS.org(Dynamic DNS),DyDNS.org(Custom DNS),DyDNS.org(Static DNS),
www.zoneedit.com,www.no-ip.com.
A description for each item as following:
Enable or disable DDNS service.
Choose the service provider from the drop down list
Input user name with DDNS registry.
Input password with DDNS registry.
Input domain name with DDNS registry.
Click “Apply” to confirm the changes.
To Next Page
Loading...
Need help?
General