Reading the note and check on “Accept” for confirmation.
Now, from the data guard task list will have created task listed. To start the iSCSI
volume backup, select the task and click “Start” from task bar.
Once “Start” click, the associated iSCSI volume will not allow to I/O during backup
processing. And the task status will change to ‘Processing”.
States change to “Finish” after task complete.
From the RAID volume folder ‘andy_local’, it has backup iSCSI volume file stored.
This backup iSCSI volume file is needed while it required import to storage. Next
topic will describe about this.
To Next Page
Loading...
