With this newly attached stack target device, you will see the information displayed
and also have access to several options to choose from.
In general, if the attached stack target device has been used by another Thecus NAS
as stack target volume, then the Format item will be display and system will
recognize it straight away and display its capacity. Otherwise, the Format item will
be available and the Capacity and Status items will show as “N/A” and “Unknown
file system” respectively.
Next, click Format to proceed with formatting.
After the format is completed, the stack target volume will be created successfully.
You will see the volume’s capacity and status in the Stack Target List screen.
C. Edit a Stack Target
To make any changes to a stack target, click Edit for the corresponding stack
target, and the system will bring up the following dialogue window:
After your changes have been made, click Apply to confirm any modifications.
Once changes are applied, the associated information will be updated on the Stack
Target List window.
D. Stack Target ACL
If the stack target Public setting set to Yes, then the ACL button will be grayed out.
However, if Public setting is set to No, then the ACL button will be available for
you to setup user access permissions for the stack target.
To Next Page
Loading...
Need help?
General