THERMAL INNOVATIONS (UK) LTD | THERMAFLOW® ELECTRIC COMBINATION BOILER | Tel: 0870 850 5207
7
PART1 - INSTRUCTIONS FOR USE
1.1 INTRODUCTION
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure they do not play with the appliance.
Please read these Instructions and follow them carefully for the safe and economical use of your
combination boiler.
This boiler must have been installed by a competent person in accordance with the current rules in
force in the countries of destination at the time of installation.
The boiler is automatic in operation once the external controls are set e.g. time clock or
programmable room thermostat.
IMPORTANT NOTICE
1.2 Domestic hot water temperature
Hot water is user adjustable by turning the control knob on the thermostatic mixing valve fitted on the
hot water outlet at the top left of the boiler. It has a maximum anti-scald cut off at 63oC.
The combination boiler is able to provide room heating as part of an underfloor or central heating
system and domestic hot water direct from the cold water supply, without the need for secondary
storage.
1.3 To turn the boiler off
To turn the boiler off, isolate the boiler from both the electrical supplies i.e. the 24hr supply and the
interrupted supply, both isolating switches should be positioned next to the boiler.
1.4 Maintenance and servicing
To ensure the continued efficient and safe operation of the appliance it is recommended that it is
checked and serviced as necessary at regular intervals. The frequency of servicing will depend upon
the particular installation conditions and usage, but in general once a year should be enough.
Servicing & maintenance should be carried out by a competent person in accordance with the rules in
force in the countries of destination.
To obtain service please call your installer or Thermal Innovations (UK) Ltd, using the telephone
number on the appliance or at the front of this manual.
Please be advised that the Thermal Innovations (UK) Ltd log book should be completed by the
installation engineer on completion of commission and servicing.
1.5 Clearances
The boiler requires a clearance in front and at the sides for safety, servicing and maintenance access,
see diagram 2.2.3 for the requirements.
To Next Page
Loading...