Thermia iTec User Manual

6.5 Cleaning the strainer for the heating circuit
N
The heat pump must be switched off at the
main switch before the cleaning can be star-
ted.
N
The strainer must be cleaned twice a year after
installation. The interval can be extended if
there is evidence that cleaning twice a year is
not necessary.
N
Have a cloth at hand when opening the strain-
er cover as a small amount of water usually es-
capes.
A
D
C
B
A: Stopcock
B: Cover
C: Strainer
D: O-ring
Clean the strainer as follows:
1. Switch off the heat pump.
2. Turn the stopcock to the closed position (see figure above).
3. Unscrew the cover and remove it.
4. Remove the strainer.
5. Rinse the strainer.
6. Reinstall the strainer.
7. Check that the o-ring on the cover is not damaged.
8. Screw the cover back into place.
9. Turn the stopcock to the open position.
10. Start the heat pump.
User Guide
iTec
Thermia Värmepumpar VUJSI102
25

Thermia iTec Specifications

General

Brand	Thermia
Model	iTec
Category	Heat Pump
Language	English