Thermia iTec - Default Control Computer Settings; Factory Default Parameter Reference

7 Default setting in the control computer
The first column in the table below shows the parameters that can be adjusted by the User. The second column
shows settings made at the factory, and the third column the settings made by the installation contractor in
connection with installation of the heat pump.
Setting Factory setting Any customer specific settings
ROOM 20°C
OPERAT. AUTO
CURVE 40°C
MIN 10°C
MAX 55°C (45°C for under floor heating)
CURVE 5 0°C
CURVE 0 0°C
CURVE -5 0°C
HEAT STOP 17°C
User Guide iTec
VUJSI102 Thermia Värmepumpar
26