Symbol Description
Operating mode Auxiliary heater + service.
External functions are on.
Auxiliary heater enabled and activated.
In this mode the heat pump (compressor) is disabled, but the
unit can produce heating and hot water with the internal im-
mersion heater (and/or external auxiliary heater if activated).
This operating mode must be used if heating and/or hot water
is needed, but the compressor must be disabled e.g. when the
brine circuit is not available or installed.
Operating mode On. All activated functions are on.
In this operating mode, functions enabled in Settings can be
switched activated or deactivated.
Press
to go to page 2 where functions can be activated/
deactivated.
See the example in the table below.
Operating mode On. All activated functions are on.
In this operating mode, functions enabled in Settings can be
switched activated or deactivated.
Auxiliary heater enabled but not activated.
Press
to go to page 2 where functions can be activated/
deactivated.
See the example in the table below.
The list below shows examples of selected
functions on page 2 in Operating mode.
Functions not activated from factory must be
enabled in Settings before they can be activa-
ted and used.
User Guide Mega
Thermia Värmepumpar VUJSC302
15
To Next Page
Loading...
