RC12
BP™
Installation
2-3
Figure 2-2. Centrifuge Dimensions
Installation
A Preinstallation Kit (Catalog No. 22001) is supplied for UL/CE
compliance. Install the Preinstallation Kit according to instructions
supplied with the kit.
To install the RC12BP™:
1. Position the RC12BP™ in an operating location that satisfies the
criteria specified in the previous Location paragraph. With the
Preinstallation Kit installed, the operating location is so that the
two tabs (under the front edge of the centrifuge) are flush against
and aligned with the preinstalled hold-down brackets.
2. Secure the centrifuge to the brackets by installing a shackle and
a locking bolt (supplied with the kit) through each tab/hold-down
bracket eyelet and tightening.
To Next Page
Loading...
