Operation
SORVALL
®
Centrifuges
4-6
Using Advanced Features (Options)
The advanced features of the RC12BP™ allow for: performing
quality control runs, changing speed or time control ranges, changing
acceleration/deceleration or overtemperature alert settings, linking-
together programmed run parameters, and saving run parameters to
program memory for simple recall. Detailed description of each of the
advanced features can be found in Chapter 3.
Advanced feature selection is usually reflected by LED option status
indicators – when a feature has been selected, the corresponding
indicator will be lit (although specific settings for several features can
only be checked by reselecting the feature in the options screens). If
changes to advanced feature selection are required (other than to
RPM/RCF or TIME/HOLD/ACE status, which are accessible through
primary function keys), the features are accessed by pressing MENU
and then pressing ENTER until the selection screen of the particular
feature appears in the SET display.
Pressing ENTER steps through the options screen sequence without
changing preexisting selection status (unless a new value is input).
Selections are made by inputting 1 or 0, then entering any required
setting values that may be prompted on a subsequent screen for that
option.
After the last option in the options screen sequence (SAVE TO
PROGRAM MEMORY?), the HOME screen will reappear in the
SET display. If you wish to exit the sequence before that, MENU may
be pressed at any time to return to the HOME screen.
To Next Page
Loading...
