-13-
-14-
EN
EN
2. The remote sensor (transmitter) can be placed on a flat
indoor or outdoor. Make sure the sensor is within the transmission
distance from the base station and with minimal obstructions.
surface
4. The base station and remote sensor can both be wall mounted.
3. Although the remote sensor is designed to be rain-proof, the remote
sensor must be always placed upwards so that rain won't get inside
the sensor through the vent holes on the bottom of the senor which
functions to let the remote sensor detect the environmental
temperature and humidity more precisely and quickly.
Maximum & Minimum Recorded Temperature & Humidity
1. Press MAX/MIN/Clear button once to display the highest indoor and
4. When either the MAX or MIN record is shown on the LCD
press ALL-TIME/24 button once to set the data record time interval
between ALL TIME or 24 hours. Note: Both ALL TIME and 24 hours
represent the time since you last time manually cleared the history
data or battery installation.
display,
Purchasing Additional Remote Sensors
The model number of the remote sensor for this unit is TPR65.
Additional sensors may be ordered directly from Amazon or
by contacting our customer service listed below.
ThermoPro
outdoor temperatures/humidity recorded since last reset. MAX is
shown on the display.
2. Press MAX/MIN/Clear button again to display the lowest indoor and
outdoor temperatures/humidity recorded since last reset. MIN is
shown on the display.
3. To clear and reset the max/min records, when either the
MIN record is shown on the LCD display, press and hold MAX/MIN/
Clear for 3 seconds.
MAX or
Place the Base Station and Remote Sensor
1. The indoor base station (receiver) should always be placed in a well
ventilated indoor area and located away from vents, heating or cooling
elements, direct sunlight, windows, doors, or any other openings.
after that you can select any channel you like or auto-scroll mode.
keep changing from channel to channel in the first three minutes,
To Next Page
Loading...
