EasyManua.ls Logo

ThermoPro TP-60S - Specifications; FCC Statement of Compliance

ThermoPro TP-60S
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-15-
-16-
EN EN
Specifications
1. 433 Mhz transmission frequency.
2. Transmission range up to 200 ft. (range maybe shorter
interference present).
based on
FCC Statement of Compliance
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
l) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
8. Power: 2 X AAA 1.5V for base unit and 2 X AAA 1.5V for remote sensor.
7. Humidity tolerance: ±2% from 30% to 80%; ±3% below 30% and
above 80%.
3. Indoor Temperature range: -4°F~158°F (-20°C~70°C).
4. Outdoor Temperature range: -58°F~158°F (-5C~70°C).
5. Humidity range: 10% ~ 99%.
6. Temperature tolerance: +/- 2.0°F (+/- 1.1°C).
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different
which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
from that to

Related product manuals