SAFETY PRECAUTION
INITIAL USE
START CALIBRATION
TARGET PATTERN KIT
PRODUCT PROFILE
14
Warning:
Batteries can deteriorate, leak or explode, and can cause injury or fire.
1. Do not shorten the battery terminals.
2. Do not charge Alkaline batteries.
3. Do not mix old and new batteries.
4. Do not dispose of batteries into household waste.
5. Do not dispose batteries in fire.
6. Defective or dead batteries must be disposed according to local regulations.
7. Keep the batteries out of reach from children.
If the laser level will not be used for a long period, remove the batteries from the battery
compartment. This will prevent batteries from leaking and corrosion damage.
Technical parameters:
Laser beams output pattern
• Horizontal and forward vertical cross beams
• Horizontal, forward and backward vertical beams
• Horizontal and 4 orthogonal vertical beams
Plumb down dot appears while vertical beam is ON
• Horizontal beam
Laser range
• Indoor - 30m (100ft)
• Outdoor with detector 60m (200ft)
Accuracy
Accuracy (plumb Dot)
±0.2mm/m (±0.0002in/in)
±1mm/1.2m
Fan angle 120°±5°
Self-leveling Range ±2.5°
Laser line width
2 mm±0.5mm/5m
(0.10” ±0.02” at 20’ )
Wavelength 520 ±10nm - Laser Class II
Power supply
Li-Polymer battery pack or
4 AA Alkaline batteries (not included)
Battery life
2.5 hours continuous operation with Li-Polymer
5 hours with 4AA Alkaline batteries
Operating temp. -10° C + 45° C (14°F +113°F)
Storage temp. -20° C +60° C ( -4°F +140°F)
Water & dust proof IP54
Dimensions ø150mmx195mm (ø 6” x8”)
Weight without batteries 1250gr ±10gr (2.75lbs± 0.35±oz )
THINKCAR ADAS Calibration Tool
To Next Page
Loading...
