Thinkware DC-M2-FG - 2. Installing the Product (continued); 2.3 IR Camera Installation; 2.3.1 Location Selection; 2.3.2 Securing the IR Camera

Installing the product
16
3
Turn on the ACC or start the engine to check if the product is powered on. After the product is powered
on, the Status LED and the voice guidance will be turned on.
The product is powered on when the ACC mode is turned on or when the engine starts.
2.3󳒀 Installing the IR camera
2.3.1󳒀 Selecting an installation location
Install at any suitable location near the dash cam.
Ensure the following conditions are met before installation:
•󳒀 Ensure that the dash cam is off.
•󳒀 Ensure that the interior infrared camera does not obstruct the driver's view.
•󳒀 Ensure that the room mirror or the dash cam does not block the interior infrared camera.
•󳒀 Ensure that the installation location can be easily accessed.
•󳒀 Note the interior infrared camera's direction before installation.
•󳒀 Ensure that the THINKWARE logo on the camera mount is facing the windshield when installing the
prevent the video from being recorded upside down.
2.3.2󳒀 Securing the IR camera
1
After selecting an installation location, clean the spot using a dry rag or cloth.
If the installation surface is wet, or if foreign materials are on the surface, the interior infrared camera
may not be firmly attached to the windshield and may become detached while driving.
2
2
1
➊➊
➋➋
Remove the protective film from the mount's
installation surface.