Thinkware F200 PRO - Installing the Product

9
Installing the product
Select an installation
location that can record the
entire view in front of the
vehicle without obstructing
the driver’s vision. Ensure
that the front camera lens is
located in the center of the
windshield.
1.Refertotheguresbelowtoinstallthecameratothewindshield.
3
2
1
4
➊➊
➋➋
➌➌
➍➍
2. Remove the product from the mount, and then push the mount against
thewindshieldtoxitrmly.
3. Reattach the product to the mount, and then adjust the camera angle.
• Toconrmthecameraangle,recordavideoafterinstallationandcheck
the video using the mobile viewer or the PC viewer. If necessary, adjust
the camera angle again.
• The product may fall and be damaged during vehicle operation if it is not
rmlyxedtothemount.
• If you need to remove the mount from the windshield to alter the
installationlocation,becarefulnottodamagethewindshield’slmcoat.
F200PRO_QSG.indb 9F200PRO_QSG.indb 9 2021-08-09 오후 1:30:252021-08-09 오후 1:30:25