There are two ways to send MIDI program changes. You can either send a single spe‐
cific program number (rotary control knob assignment remains unchanged), or you
can assign the data control to the rotary control, so that MIDI program changes are
sent.
n Sending a single specific program number (rotary control knob assignment
remains unchanged)
Press the [FUNCTION] button, to enter edit mode.
Press the piano key F
#
5.
Enter the program number you want to send using the keys for numeric input.
As an alternative to entering via the function keys for numeric inputs, you
can select the MIDI program number in this step aslo using the rotary con‐
trol [DATA CONTROL].
Press the input key C7 to send the MIDI command.
n Sending MIDI program changes using the rotary control [DATA CONTROL]
Press the [FUNCTION] button, to enter edit mode.
Press the piano key F
#
1. The display briefly shows
.
Sending MIDI program changes
MIDI functions
DP-25
35
To Next Page
Loading...
Need help?
General
