If you activate the reset function by simultaneously pressing the [TRANSPOSE] and
[OCTAVE] buttons, the digital piano carries out the following procedures:
1. Turning on internal sound generator.
2.
Sending All Notes Off command on MIDI channel 1 (external) and to the
internal sound generator.
3.
Sending Reset All Controllers command on MIDI channel 1 (external) and to
the internal sound generator..
4. Assigning metronome tempo control function to [DATA CONTROL] rotary
button.
5. Volume reset to default value for main voice, split voice, and layer voice
volume.
6. Setting pan function for main voice, split voice, and layer voice.
7. Turning off layer mode and split mode.
8. Setting main MIDI send channel to 1.
9. Resetting transpose and octave shift function to 0.
10.
Sending Program Change = 0 to channel 1.
11.
Sending Bank Change MSB = 0 and Bank Change LSB = 0 to channel 1.
12. Resetting effect depth for reverb to the default setting for the main voice.
13. Resetting effect depth for chorus to the default setting for the main voice.
14. Sending the current state of the sustain pedal on channel 1.
Performing a factory reset will clear the settings of all functions of the digital piano
that were previously stored by the user and restore all functions to their factory
defaults. Thus, the piano is in the same condition as when you used it for the first
time. Please note that anything you have recorded in the song recorder will be
erased by this procedure!
1. Turn off the digital piano using the [POWER] switch.
Piano reset
Factory reset
Appendix
DP-25
47
To Next Page
Loading...
Need help?
General
