Start check:
• The following must light up when the power unit has been
switched on:
the main switch, the display (shows the setting for charging voltage)
Note:
• The LED for connection of a gun with hoisting magnet has no
function when the gun C0 is being used.
• Hold the gun with stud against the workpiece: the contact LED
must light up (when earth cable – on both sides – and welding cable connected).
• Hold the gun in the air and press the start button: the start LED
must light up.
• Otherwise no further LEDs should light up.
Troubleshooting
See Troubleshooting chapter 5.1 Troubleshooting.
13
To Next Page
Loading...