16
1.14 Angle bracket
With the angle bracket you can approach a right-angled
surface to up to 8 mm with the gun and weld studs (order
no. see chapter 5.10).
1.15 Bending device
The bending device is used in impact bending tests (see
chapter 4.7).
It is manufactured according to DIN 0905 Part 2. The five
inserts must be ordered individually (order nos. see chapter
5.10).
1.16 Chucks (standard)
These chucks are used for threaded studs and un-
threaded studs (order nos. see chapter 5.10).
To Next Page
Loading...