5
Getting started
EN
Manual programming
This method involves carrying out a manual search for the codes to
be used for controlling your other appliances.
1. Switch on the appliance you wish to use the remote control
with.
2. Press the relevant button for this appliance on the remote
control, and while holding this button down, enter one of the
codes relevant to your make of appliance (there is a list of codes
at the end of this manual). If the appliance buttons of the remote
control fl ash you have entered the wrong code or it is not
possible to program the remote control.
3. Point the remote control at the appliance and press the
relevant button (
VCR, DVD, etc). Press the standby button.
If the appliance does not go into standby mode, try another
code.
Depending on the year of manufacture and the type of appliance,
some functions may not be available. Certain codes may cover
more functions than others. Test the functions you can control and,
if appropriate, try other codes. Note here the code(s) which work
best.
VCR AUX
DVD AMP
SAT
When you change the remote control’s batteries, remember
to reprogram it.
Programming the volume control function
If you have programmed the TV remote control to use with other
appliances and these are connected to an amplifi er you can also
programme the remote control to adjust the volume when you
are using one of these appliances. The example below describes the
procedure for programming a DVD player.
1. Programme the AMP button on the remote control to use
with the amplifi er (refer to page 4).
2. Move the remote control away from the appliances. Press the
-
button and while holding it down, press the relevant mode
button (
DVD, in this example), then the AMP button. Release
the
-
button.
3. Switch on the amplifi er, then the DVD player.
4. Set the remote control to DVD, play a disc and adjust the
volume using the
+/-
buttons.
Repeat this operation for the other appliances.
To cancel the programmed function for any of the appliances, press
the
-
button, while holding it down and enter the code 000
using the numeric buttons.
Video recorder DVD player Satellite receiver Hi-fi system
Press the VCR button. Press the DVD button. Press the SAT button. Press the AMP button.
On/Standby On/Standby On/Standby On/Standby
MENU To display the main menu To display the main menu To display the main menu
Vertical scrolling in menus Vertical scrolling in menus Vertical scrolling in menus
Horizontal scrolling in menus Horizontal scrolling in menus Horizontal scrolling in menus
OK To confi rm an action To confi rm an action To confi rm an action
EXIT To close a menu To close a menu To close a menu
0-9 To directly access channels To enter numeric values To directly access channels To select a station using
or enter numeric values or select options in menus or enter numeric values its number
PR+/PR- To change channels To change chapters To change channels To change stations
AV To select AV input To select AV input
REV Rewind Rewind
PLAY Play Play
FWD Fast forward Fast forward
STOP Stop Stop
PAUSE Pause picture Pause picture
REC Record
MUTE To switch the sound off and
back on again
+/- To set the volume level
Important:
If the batteries in your remote control are run down you can use the buttons on
the front of your TV set as they have the same functions as the corresponding
buttons on the remote control.
130-EN-DVBT.indd 5130-EN-DVBT.indd 5 26/01/06 14:19:0526/01/06 14:19:05
To Next Page
Loading...
