THOMSON SpeedTouch 180 User Manual (English)

Other manuals for THOMSON SpeedTouch 180

Questions and Answers:

T
Terry JonesJul 29, 2025
How to improve wireless connectivity on THOMSON SpeedTouch 180?
- B
  Betty MeyersJul 29, 2025
  To improve wireless connectivity or reach on your THOMSON Wireless Access Point: * Move your wireless devices closer to the SpeedTouch™ to get a better signal. Try adjusting the antenna angle as well. * Interference from devices like microwave ovens or cordless phones can be a problem. Try moving either the interfering device or the SpeedTouch™. * Consider changing the wireless channel on the Access Point. * Ensure the antenna, connectors, and cabling are securely connected.
J
Jim MillerAug 2, 2025
Why my THOMSON SpeedTouch 180 cannot be detected?
- E
  Edwin PughAug 2, 2025
  If your THOMSON Wireless Access Point (SpeedTouch™) cannot be detected by a wireless client: * Ensure the distance between the SpeedTouch™ and the wireless clients is not too far. * Verify that the wireless clients are using the same wireless settings (SSID and security settings) as the SpeedTouch™.
J
joseph10Aug 7, 2025
What to do if I cannot connect to THOMSON SpeedTouch 180 Wireless Access Point using the web browser?
- G
  Gabriel SanchezAug 7, 2025
  If you can't connect to your THOMSON Wireless Access Point using a web browser: * Make sure that you have configured the SpeedTouch™ with a valid IP address, subnet mask, and default gateway. * Check that you have a valid network connection to the SpeedTouch™ and that the port you are using has not been disabled. * Check the network cabling between the management station and the SpeedTouch™.
Y
yolanda36Aug 11, 2025
What to do if wireless PC cannot connect THOMSON SpeedTouch 180?
- G
  Glenn TuckerAug 12, 2025
  If a wireless PC cannot associate with the THOMSON Wireless Access Point device: * Ensure that the wireless clients are using the same SSID settings as the SpeedTouch™. * Verify that the security settings are identical on both the clients and the SpeedTouch™. * If using a WPA RADIUS server, confirm that the RADIUS server is active.
T
Tony MoralesAug 15, 2025
How to restore THOMSON SpeedTouch 180 if I forgot password?
- N
  Nicole SmithAug 15, 2025
  If you forgot or lost the password for your THOMSON Wireless Access Point, restore the SpeedTouch™ to its factory defaults.
M
Michelle AlvaradoAug 19, 2025
What to do if LAN LED does not light up on THOMSON SpeedTouch 180 Wireless Access Point?
- A
  Anthony FreemanAug 19, 2025
  If the LAN LED on your THOMSON Wireless Access Point does not light up: * Make sure that the LAN cable is securely connected to the 10/100Base-T port. * Ensure that you are using the correct cable type for your Ethernet equipment. * Check that the computer's Ethernet port is configured for auto-negotiation.
K
Kristin RothAug 25, 2025
Why loop has been detected on THOMSON SpeedTouch 180 in Repeater mode?
- T
  Tiffany HoAug 25, 2025
  A loop detection in Repeater mode on your THOMSON Wireless Access Point is caused by a broadcast storm resulting from incorrect setup.

THOMSON SpeedTouch 180 Specifications

General

Frequency Band	2.4 GHz
Antenna Type	Internal
Connectivity Technology	Wireless
Wireless Standard	802.11b
Ethernet Ports	1 x 10/100 Mbps
Security	WEP
Data Link Protocol	Ethernet, Fast Ethernet, IEEE 802.11b