T
ROUBLESHOOTING
A-4
Wireless Problems
A wireless PC
cannot associate
with the device.
• Make sure the wireless clients use the same SSID
settings as the SpeedTouch 180.
• You need to have the same security settings on the
clients and the SpeedTouch 180.
The wireless
network is often
interrupted.
• Move your wireless clients closer to the SpeedTouch
180 to find a better signal. If the signal is still weak,
change the angle of the antenna.
• There may be interference, possibly caused by
microwave ovens or cordless phones. Change the
location of the interference sources or of the
SpeedTouch 180.
• Change the wireless channel on the 11g WDS-enabled
device.
• Check that the antenna, connectors, and cabling are
firmly connected.
The
SpeedTouch 180
cannot be
detected by a
wireless client.
• The distance between the SpeedTouch 180 and
wireless clients is too far.
• Make sure the wireless clients use the same SSID,
channel, and security settings as the SpeedTouch
180.
In Repeater
mode, a loop has
been detected.
• A broadcast storm has resulted from incorrect set up.
Please refer to page 3-23.
Troubleshooting Chart
Problem Action
To Next Page
Loading...
