7. MAIN MENU
P17
new satellite when you have added the appropriate transponder. The full editing functions are available in the
Channel Search menu. Here use the pq buttons to navigate.
Frequency: Enter a frequency with the 0 ~ 9 buttons.
Symbol rate: Enter the required symbol rate with the 0 ~ 9 buttons.
Polarization: Here the polarization can be changed with tu.
By pressing the pq buttons you can select OK to change or Cancel to discard.
After all settings are adjusted according to your system requirements, press to leave this menu. A message
will inform about the changes, use the pq buttons to select Yes to save or No to discard and confirm with OK.
The receiver will return to the selection screen and you can continue.
If you want to delete a satellite press the GREEN button. If you want to delete all satellites that have been setup
press the YELLOW button to do so. When all settings have been made, press to leave this menu.
7.1.2 Channel Search
Use this menu to perform an automatic, network or transponder channel search or to search on all satellites that
have been setup. Use pq to highlight an item and tu to change settings. Below the settings you can find
the search method selection.
Antenna Here you can change the antenna port with tu if you have configured more than
one satellite.
Satellite Here you will see the satellite that is assigned to the antenna in above, you can only
see the satellite(s) which has/have been setup in the Antenna Setup menu before.
Transponder list By pressing tu you can change between the transponders referring to the selected
satellite, you can also press OK to list up and select with pq or P+/P-. Afterwards
press OK to choose. Press RED to Edit TP, with GREEN you can Delete TP and with BLUE
you can enter data for a new transponder Add TP.
For the further procedure in Edit TP and Add TP see chapter 7.1.1.2 Add TP. In Delete TP a message will be
displayed to apply your changes, use pq to select Yes to apply or No to cancel and confirm with OK.
Scan Mode Here you can decide which channels you want to scan for: Either scan all channels FTA
& $, for Free-To Air only FTA or use CA to scan for scrambled channels only.
Channel Type TV & Radio will scan for TV and radio channels, TV for TV channels only and Radio for radio channels
only.
After you have adjusted the settings for the preferred scan process, move to Scan selected satellite with pq and
then select the search method with tu.
You can select between following procedures:
Scan selected satellite Scanning the selected satellite.
Search All Sat Scanning the selected satellites.*
Search TP Scanning the selected transponder.
Network Search NIT scanning the selected satellite.
Fast scan: Will rescan the channel list supplied by the operator that you have chosen. Fast Scan is
only available on Astra 23.5E.
When all settings have been made, press OK at the preferred scan method to start this scan process or
to
quit without scanning. All newly found channels will be stored at the end of the channel list.
*Only available if more than one satellite have been setup.
NOTE: NIT (Network Identification Table): This option will scan on the NIT table of the satellite and allows
you to receive new appeared channels.
NOTE: When you want to add technical data for a new transponder we recommend verifying it by
consulting websites like: www.lyngsat.com or www.kingofsat.net or you can refer to professional
journals.
To Next Page
Loading...
