37
Adjusting the Tracking Force
After you have adjusted the tonearm‘s neutral
position as described, you can use the dial on
the top of the tonearm bearing to set the rec-
ommended tracking force for the cartridge. The
recommended value can be found in the techni-
cal specifications of your cartridge.
Move the metal lever on the left side of the
tonearm bearing so that the small pin in the
scale points exactly to the desired value. (Fig.
15) In most cases this method of adjustment is
suciently accurate. If you want an absolutely
perfect experience, please use a stylus gauge.
As described above, move the lever on the
tonearm bearing so that the stylus gauge indi-
cates the desired value. (Fig. 16)
ADJUSTING THE TRACKING FORCE
Fig. 15 Fig. 16
To Next Page
