EasyManuals Logo

THORLABS PM103 User Manual

THORLABS PM103
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Rev: 1.1, 22-Jun-2023 © 2023 Thorlabs
Page 1
PM103x Optical Power Meter Interfaces Chapter 1 Safety
Chapter 1 Safety
Attention
The safety of any system incorporating the equipment is the responsibility of the assembler of the
system.
All statements regarding safety of operation and technical data in this instruction manual will only
apply when the unit is operated correctly as it was designed for.
The PM103x must not be operated in explosion endangered environments!
Only with written consent from Thorlabs may changes to single components be made or components
not supplied by Thorlabs be used.
All modules including control inputs / outputs and the sensor must be connected with duly shielded
connection cables.
Attention
The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and meets all requirements of the Canadian Interference-Causing
Equipment Standard ICES-003 for digital apparatus. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/T.V. technician for help.
Thorlabs GmbH is not responsible for any radio television interference caused by modifications of this
equipment or the substitution or attachment of connecting cables and equipment other than those
specified by Thorlabs GmbH. The correction of interference caused by such unauthorized modification,
substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
Attention
Mobile telephones, cellular phones or other radio transmitters are not to be used within the range of
three meters of this unit since the electromagnetic field intensity may then exceed the maximum
allowed disturbance values according to IEC 61326-1.
This product has been tested and found to comply with the limits according to IEC 61326-1 for using
connection cables shorter than 3 meters (9.8 feet).

Other manuals for THORLABS PM103

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS PM103 and is the answer not in the manual?

THORLABS PM103 Specifications

General IconGeneral
BrandTHORLABS
ModelPM103
CategoryRecording Equipment
LanguageEnglish

Related product manuals