www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
There is laser power supplier, Ammeter, TL-Timer etc. please open this door for
checking these parts, but must pay attention to the electric current.
6. X-axis
The motion system is that performs the mechanical movements in X direction. The
X-axis is visible in the working area.
7. Laser head
Laser beam and red dot pointer are all come out from the laser head, and the Auto
Focus switch is installed on the laser head, too. The bottom of laser head is parallel to
the bottom of the autofocus switch.
8. Front door
Open this door for cleaning the waste after working.
This door is locked by using two outside locks.
9. Honey comb table
The honey comb plate to be processed is put onto the working table. Put the material
on the working table for engraving & cutting
10. Y-axis
The motion system is that performs the mechanical movements in Y direction. The
Y-axis is visible in the working area.
11. Front up door
Open this door for take out the honey comb table and it’s convenient to put that
material on working table
This door is locked by using inside screws and outside locks.
12. Flap protection sensor
This is where Open flat protection exist. Laser will stop working once the cover is
opened during working.
13. Control panel
You can control the X-axis, Y-axis and Z-axis manually by the display panel, it also
shows the working time, power, speed and the whole working time and affords many
function options(please view this chapter 4.3 for detail).
14. Emergency stop switch
Once there’s an accident happen (laser catch fire, laser out leakage) during working,
please turn off this switch immediately. It will be cut off the laser power and motion
power immediately.
15. LED lamp
It’s used for lighting the working table once turn the Main switch on.
16. Laser power switch
To Next Page
Loading...
