the value at the display, press
Start/Enter
key to
make it blink then change the value using
INC
or
DEC
key. The value will be stored by pressing
Start/Enter
key once.
To start the process, press
Start/Enter
button for
more than 3 seconds.
Charging NiCd/NiMH battery
This program simply charges the battery using the
current you set. In “Aut” mode, you need to set the
upper limit of charge current to avoid from higher
feeding current that may damage the battery. Because
some batteries of low impedance and small capacity
can lead to the higher charge current by the processor
at automatic charge mode. But in “Man” mode, it will
charge the battery with the
charge current you set at
the display. Each mode can
be switched by pressing
I N C
a n d
D E C
b u t t o n
simultaneously when the
current eld is blinking.
The screen displays the
current state of charging.
To stop the process, press
Batt type/Stop
key
once.
The audible sound indicates
you the end of process.
NiMH CHARGE Aut
CUR LIMIT 5.0A
Display
- +
DEC INC
Display
Batt type
Stop
Start
Enter
'>3 seconds'
NiMH 2.0A 7.42V
CHG 022:45 00890
Display
Display
battery
type
elapsed
time
charge
current
battery
voltage
charged
capacity
To Next Page
Loading...
Need help?
General
