This program monitors
the v o ltage of input DC
battery. If the voltage drops
below the value you set the
operation forcibly terminated
to protect the input battery.
Lithium battery (Lilo/LiPo/Life) program
These programs are only suitable for charging and
discharging Lithium batteries with a nominal voltage of
3.3V, 3.6V and 3.7V per cell. These batteries need to
adopt different charge technique is termed a constant
voltage (CV) and constant current (CC) method. The
charge current varies according to the battery capacity
and performance. The nal voltage of charge process is
also very important; it should be precisely matched with
the charade voltage of the battery. They are 4.2V for
LiPo, 4.1V for Lilo, and 3.6V for LiFe. The charge current
and nominal voltage as for cell count set on the charge
program must always be correct for the battery to be
charged.
When you are willing to alter the parameter value in the
program, press
Start/Enter
key to make it blink then
change the value with
INC
or
DEC
key. The value will
be stored by pressing
Start/Enter
key once.
Charging Lithium battery
The left side of the rst line shows the type of battery
you select at the users setting. The value on the left side
of second line sets a charge current and the value on the
right side of second line sets the voltage of the battery
Input power Iow
Cut - Off 10.0V
Display
- +
DEC INC
Display
To Next Page
Loading...
Need help?
General
