Thunder T6 User Manual

16
pack.
After setting the current
and voltage press
Start/
Enter
key for more than 3
seconds to start the process.
(Charge current: 0.1—
5.0A, Voltage: 1—6 series)
This shows the number of cells you set up and the
processor detects. “R:” shows the number of cells
found by the charger and “S:” is the number of cells
selected by you at the previous screen. If both numbers
are identical you can start
charging by press
Start/
Enter
button. If not, press
Batt type/Stop
button
to go ba ck to pr evi ou s
sc r e e n. T h e n c a r ef u l l y
check the number of cells of
the battery pack to charge
again.
The screen shows the
present situation during
charge process. To stop
c h a r g i n g p r e s s
B a t t
type/Stop
key once.
Charging Lithium battery at balance mode
This is for balancing the voltages of Lithium batteries
R:3 SER S:3SER
CONFIRM(ENTER)
Display
Display
Start
Enter
Li3S 2.0A 12.59V
CHG 022:43 00682
Display
Display
number
of
cells
charging
time
charge
current
battery
voltage
charged
capacity
LiPo CHARGE
2.0A 11.1V(3S)
Display
- +
DEC INC
Display
- +
DEC INC
Batt type
Stop
Start
Enter
'>3 seconds'

Thunder T6 Specifications

General

Brand	Thunder
Model	T6
Category	Battery Charger
Language	English