4
Cyclic charging/discharging
Perform 1 to 5 cycles of charge> discharge or
discharge> charge continually for battery refreshing and
balancing.
PC based analysis using USB communication
For technical expert, it offers PC based program can
analysis the characteristic of the battery by USB port.
It shows a graph of voltage, current, capacity and
temperature curves. It also shows the individual voltage
of each cell in the Lithium battery pack.
PC-LINK USB adaptor can be purchased separately.
Warnings and safety notes
Those warnings and safety notes are particularly
important. Please follow the instructions for a maximum
safety; otherwise the charger and the battery can be
damaged violently. And also it can cause a fire to injure a
human body or to lose the property.
1.Never leave the charger unsupervised when it is
connected to its power supply. If any malfunction is
observed immediately terminate the process and refer to
the operation manual.
2.Keep away the charger from dust, damp, rain, heat
direct sunshine and vibration. Do not drop it.
3.The circuit of this charger is designed to be powered
by a 12V DC. But do not supply both
input power
simultaneously. The circuit can be damaged permanently.
4.This charger and battery to be charged and
discharged should be set up on a head-resistant, non-
inflammable and non-conductive surface. Never place
them on a car seat, carpet or similar.
To Next Page
Loading...
Need help?
General
