less
min. discharge voltage cut off level:
1.75V/cell or higher
7.To avoid short-circuits between the charge lead,
always connect the charge cable to the unit rst and only
then to the battery to be charged or discharged. Reverse
the sequence when disconnection.
8.Do not connect more than one battery pack to charge
at any one time.
9.Do not attempt to charge or discharge below types of
battery:
1)Battery pack, which consists of different types of cell
(including different manufacturers).
2)Battery, which is already fully charged or just slightly
discharged.
3)Non-rechargeable batteries. (Explosion hazard)
4)Batteries that require a different charge technique
from NiCd, NiMH, Lilon, LiPo, LiFe or Pb.
5)Faulty or damaged battery.
6)Battery fitted with an integral charge circuit or a
protection circuit.
7)Batteries installed in a device, or which are electrically
linked to other components.
8)Batteries that are not expressly stated by the
manufacturer to be suitable for the currents the charger
delivers during the charge process.
10.Please check below point before charge operation.
1)Select the appropriate program which is suitable for
the type of battery.
2)Set up adequate current for charging or discharging.
3)Lithium battery pack can be composed with parallel
To Next Page
Loading...
Need help?
General
