OPERATING MANUAL 2. TRANSPORT AND STORAGE
ThyssenKrupp Aufzugswerke GmbH 11 Issue 06.2004
Dimensions and weight
The weight is indicated on a sticker on the packing of the machine.
For dimensions see delivery note.
For rough data see chapter 3.3 Technical Data
Examination by customer on receipt of goods
Examine the delivered parts for completeness, damage or anything strange.
Report and document transport damage
After receipt of goods make sure that there is no damage caused during
transport.
Information
• Immediately document the damage noticed (drawing, photograph,
description of damage).
• Immediately send the respective documents to THYSSENKRUPP
AUFZUGSWERKE GmbH.
Unpacking
Information
• Dispose packing equipment in accordance with the environmental
standards or make it available for further use.
• Special transport aids and transport contrivances remain at the
customer.
Intermediate storage
• Even if the component is not mounted directly after delivery, it should be
stored in dry places and protected with humidity-proof covering.
• Do not store the component in the open air. Parts without surface coating
lack long-time preservation.
• Open ventilation opening.
Environmental conditions
Information
Surrounding at the final site of the machine (humidity, temperature) shall
comply with the requirements for machine rooms. (Between +5° and +40°
C according to EN81).
Relative humidity of air shall not exceed 70%.
To Next Page
Loading...
