TigerStop TS Series - Set Units

16
3. TigerStop requires a password to access all menu options. Enter the
password and press
• By default, the TigerStop password is the serial number.
4. At the Menu Select screen, press the [Setup] soft key.
5. Press until reaching the FindLim screen.
6. Press to run the Find End Limit routine.
Ensure TigerStop can move its entire length without obstruction.
2. Press the [Menu] soft key.
Setup
SeT uniTS
TigerStop displays its position in either inches or millimeters.
1. From the Ready Screen, press the [Show] soft key.
2. Press the [Menu] soft key.
3. TigerStop requires a password to access all menu options. Enter the
password and press
• By default, the TigerStop password is the serial number.
4. At the Menu Select screen, press the [Options] soft key.