32
1 0
2 0
3 0
4 0
5 0
6 0
7 0
6. Enter the measurement from step 5 and then press
7. TigerStop optimizes the material up
to the defect and uses as much of
the material as possible.
If using the Standard
Interconnect Kit, TigerStop
automatically moves to the next
part length when the tool cycle
completes.
3. Press the [List] soft key.
4. Enter a list number to process and then press
• Choose a number between 1 - 100.
1 0
2 0
3 0
4 0
5 0
6 0
7 0
START
TigerStop
TigerStop
TigerStop
TigerStop
20in
20in
20
5. Make a trim cut. After the trim cut,
measure up to the first defect.
• If no defect is present, measure
the total length of the material.
1 0
2 0
3 0
4 0
5 0
6 0
7 0
8. Cut out the defect.
TigerStop
®
Standard Controller Basic Functions
To Next Page