PK-232 – MBX OPERATING MANUAL COMMAND SUMMARY
4/91 A-6 131
LINK OUT OF ORDER, possible data loss
You are CONPERMed to another packet station but the link has failed.
?VIA
You typed more than one call sign for the CONNECT or UNPROTO commands without the
VIA keyword.
?channel must be 0-9
You typed an invalid channel character after the CHSWITCH character.
?different connectees
You tried to CONNECT to more than one station on the same channel.
?already connected (or attempting connection) to that station
You tried to CONNECT to a station to which you're already connected.
too many packets outstanding
The message appears if you've typed enough data to fill the outgoing buffer in either Con-
verse or Transparent Mode. You cannot re-enter Converse or Transparent until some of
the packets have been sent.
WARNING: Beacon too often
This Warning message appears if you have set the BEACON interval timer to less than 90
(15 minutes) which is too often for busy channels.
WARNING: CHeck/FRack too small
This Warning message appears if you have set the CHECK timer for too short a time rela-
tive to the FRACK timer.
WARNING: RESptime/FRack too large
This Warning message appears if you have set the RESPTIME timer for too long a time
relative to the FRACK timer.
WARNING: TXdelay too short
This Warning message appears if the TXDELAY timer has been set too short to send at
least one complete flag before the start of a packet.
WARNING: AUdelay > TXdelay
This Warning message appears if the AUDELAY timer has been set equal to or greater
than the TXDELAY timer.
To Next Page
Loading...